US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador descarregar pdf (Página 98)

56K Softmodem

Command Reference

- 90

Base Unit: 10 min.

S36—LAPM Failure Control

•

Default: 7 (00000111b).

S37—Dial Line Rate*

This register sets the maximum line data rate. In V.90 mode, S37 controls the

upstream V.34 rate.

Range: 0—19.

Default: 0.

* The register default shown here is for North America.

Bit Description Value

0—2 Action upon LAPM failure. If S48 = 128,

the fallback options are initiated immedi-

ately after establishing the data connec-

tion. If an invalid number is entered, the

number is accepted into the register, but

S36 will act as if the default value has

been entered. Note: For performance

reasons, an error-corrected link is not

supported in V.23 (1200/75 bits/s) or any

300 bits/s mode.

0 = The 56K Softmodem disconnects.

1 = The 56K Softmodem stays on-line and a normal

mode connection is established.

2 = Reserved.

3 = The 56K Softmodem stays on-line and a normal

mode connection is established.

4 = A MNP connection is attempted and if it fails, the

56K Softmodem disconnects.

5 = A MNP connection is attempted and if it fails, a

normal mode connection is established.

6 = Reserved.

7 = A MNP connection is attempted and if it fails, a

normal mode connection is established (default).

4—7 Reserved.

—

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 107 108

Sem comentários

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador Página 98