US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador descarregar pdf (Página 35)

56K Softmodem

Command Reference

- 29

Table 3-39: N<value> Commands

\Q<value>—Local Flow Control Selection

Use this command to set the local flow control method. Result codes:

OK if <value> = 0—1, or 3.

ERROR if <value> does not equal 0—1, or 3.

Table 3-40: \Q<value> Commands

\R<value>—Ring Indicator Signal Off After Answer

This command is supported to ensure compatibility with communications

software that issues the \R0 command.

Result codes:

OK if <value> = 0.

ERROR if <value> does not equal 0.

Command Function

\N0 Buffer mode. No error control (same as &Q6).

\N1 Direct mode.

\N2 MNP or disconnect mode. The modem attempts to connect using MNP 2—4 error control proce-

dures. If this fails, the modem disconnects. This is also known as MNP reliable mode.

\N3 V.42, MNP, or buffered (default). The modem attempts to connect in V.42 error control mode. If

this fails, it will attempt to connect in MNP mode. If this also fails, the 56K Softmodem

connects

in buffer mode and continues operation. This is also known as V.42/MNP auto reliable mode

(same as &Q5).

\N4 V.42 or disconnect. The modem attempts to connect in V.42 error control mode. If this fails, the

modem disconnects.

\N5 V.42, MNP, or buffered (same as \N3).

\N7 V.42, MNP, or buffered (same as \N3).

Command Function

\Q0 Disables flow control (same as &K0).

\Q1 XON/XOFF software flow control (same as &K4).

\Q3 RTS/CTS to DTE (same as &K3) (default).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 107 108

Sem comentários

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador Página 35