US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador descarregar pdf (Página 17)

56K Softmodem

Command Reference

- 11

ERROR if <value> does not equal 0—11.

Note:ITU-T Recommendation V.250 (05/99) standardized this command. However, the standard does not

include the additional functionality added with the H1 command.

Table 3-7:

TI<value> Commands

The ATI11 results are listed on two screens. To get to the second screen, the user

must hit any key. The following is an example of the ATI11 results.

Command Function

I0, I3 Returns modem identity string and driver version number.

I1 Returns OK.

I2 Returns OK.

I4 Returns the driver build date.

I5 Returns the driver version, bus type (PCI, AC97), codec type, and country.

I6 Returns OK.

I7 Hardware version.

I8 Codec type.

I9 Returns country ID in English.

I10, I11 Displays connection information as described below. If the modem has not connected with a

remote DCE the ATI11 commands returns No Previous Call.

Description Status

Last Connection V.90

Initial Transmit Carrier Rate 26400

Initial Receive Carrier Rate 52000

Final Transmit Carrier Rate 26400

Final Receive Carrier Rate 52000

Protocol Negotiation Result LAPM

Data Compression Result V.42bis

Estimated Signal/Noise Ratio (dB) 46

Receive Signal Power Level (-dBm) 33

Transmit Signal Power Level (-dBm) 18

Round Trip Delay (msec) 13

Near Echo Level (-dBm) 24

Far Echo Level (-dBm) 80

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 107 108

Sem comentários

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador Página 17