US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador descarregar pdf (Página 28)

56K Softmodem

Command Reference

- 22

ERROR if <value> does not equal 0, 3, or 4.

Table 3-26: &K<value> Commands

&M<value>—Asynchronous Communications Mode

This command is supported to ensure compatibility with communication software

that issues the &M0 command. The preferred method for changing the

asynchronous communication mode is to use the \N<error control mode>

command.

Result codes:

OK if <value> = 0.

ERROR if <value> does not equal 0.

Table 3-27:

&M<value> Commands

&P<value>—Pulse Dial Make-to-Break Ratio Selection

This command is effective only for Japan. Result codes:

OK if <value> = 0—2.

ERROR if <value> does not equal 0—2.

Table 3-28: &P<value> Commands for Domestic Versions

&Q<value>—Asynchronous Communications Mode

This command is supported to ensure compatibility with communication software

that issues the &Q<value> command. The preferred method for changing the

Command Function

&K0 Disables flow control.

&K3 Enables RTS/CTS (hardware) flow control (default).

&K4 Enables XON/XOFF flow control.

Command Function

&M0 Asynchronous mode (default).

Command Function

&P0 Selects 39%—61% make/break ratio at 10 pulses per second.

&P1 Selects 33%—67% make/break ratio at 10 pulses per second (default).

&P2 Selects 33%—67% make/break ratio at 20 pulses per second.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 107 108

Sem comentários

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual do Utilizador Página 28