US Robotics USR8700 Guia do Utilizador descarregar pdf (Página 16)

Serial ATA 4-Drive NAS

User Guide

Getting Started - 14

2. Near the front of the tray is a spacer containing four screws. Squeeze the tabs toward each other to

remove the spacer from the tray.

3. With the flat edge of the spacer up and the screws facing a flat surface (such as a table or desk top),

flex the sides of the spacer apart from each other to release the screws.

4. Make sure that the hard disk is a SATA disk. It should have a SATA connector similar to the following:

5. Slide the new hard disk into the tray (connector end down and toward the back of the tray), and fasten

the screws on the sides of the tray:

6. Slide the hard disk and tray back into the storage system until it snaps into place.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 155 156

Sem comentários

US Robotics USR8700 Guia do Utilizador Página 16