US Robotics USR803510 Guia do Utilizador Página 9
- Página / 158
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Revision: 1.00 Copyright 2015 U.S. Robotics Corporation 9 | P a g e
While the WWAN network interface is always a direct connection to the Internet, or WAN, the Ethernet
interface and optional WLAN interface can act as either a WAN or a local Area Network (LAN). The LAN
interface allows local devices to connect to the Internet through the gateway.
The network interfaces available on the gateway are:
Ethernet interface: can be a WAN or LAN connection depending on the behavior of the WAN/LAN
switchover feature at start-up or can be set manually.
WWAN interface: always a WAN connection because it connects directly to the internet.
WLAN interface: optional Wi-Fi expansion card can be configured as either a WLAN client, which will
act as a WAN interface, or as a WLAN access point, which will act as a LAN interface.
Choosing a WAN or LAN Interface
The gateway can have only one WAN connection at a time. However the gateway can be connected to
several different LAN networks simultaneously.
In choosing the network interface, you can specify:
Manual: the network interface is selected through the embedded web interface on the Home page.
Automatic: a priority list defines which network interface to use to connect to the WAN/internet.
The network interface at the top of the list will try to connect to the WAN/internet first. If this
succeeds then the gateway continues to use this network interface to connect to the WAN/internet.
If the connection to the internet fails, the gateway tries the second interface in the priority list and
so on. The priority list is defined in the embedded web interface on the Home page.
Related Topics
Configuring the Base Unit
Ethernet Tab
3G Connection Tab
WAN/LAN switchover feature
Installing the Gateway
To install the base unit out of the box, review the installation requirements and then follow the
installation steps listed below. For information about customizing the base unit, learn about installing
expansion cards and provisioning the device with a custom developer image.
Warning: In firmware versions 1.12.0 and older, the ability to choose between automatic mode and
manual mode and to set a connection priority list are not available. These firmware versions always
try to connect to the internet over the Ethernet interface first. When this interface is not able to
connect to the internet, the gateway will try to connect to the internet via the WWAN interface.
- Table of Contents 2
- User Guide 4
- Base Unit Hardware 5
- Expansion Cards 6
- Developer card (CG1105) 7
- USR Universe 8
- Custom Developer Images 8
- Network Interfaces 8
- Installing the Gateway 9
- Installation Requirements 10
- Attaching the Antennas 11
- Installing the SIM 11
- Activating the Gateway 12
- Powering On the Gateway 13
- Installing Expansion Cards 16
- Expansion Card 17
- Mounting the Gateway 18
- Configuring the Base Unit 19
- Logging On to the Base Unit 21
- Home Tab 21
- LAN interfaces 23
- Interfaces Tab 24
- Ethernet Tab 24
- Related Topics 26
- 3G Connection Tab 27
- General 29
- Network Settings 32
- PIN Settings 33
- Ethernet Switch 34
- IP Config 35
- Data counters 36
- WLAN Access Point 37
- WLAN Client 37
- Firewall Tab 37
- Default Policies 38
- Inbound Port Forwarding 39
- Outbound Port Filtering 40
- Outbound Trusted IPs 42
- Static Routing 42
- Connection Persistence 43
- Connection Watchdog 44
- Timed Reset 45
- Provisioning Tab 46
- System Tab 47
- Time Settings 48
- Power Savings 48
- Data Counters 49
- Remote Access through HTTPS 49
- Dynamic DNS 50
- Username and Password 51
- Logging 52
- Config Export 53
- Plugin Tab 55
- Serial port settings 56
- TCP settings 57
- GPS report settings 58
- TCP/UDP settings 59
- Configuring the VPN 60
- Configuring a Tunnel 61
- Identity 61
- IKE Settings 62
- IPsec Settings 62
- Configuring Expansion Cards 63
- WLAN Client Tab 67
- Connecting to a WLAN Network 69
- Hardware Guide 71
- IP-65 requirement 72
- Front and Back Panels 73
- Front Panel 74
- Back Panel 75
- LED Descriptions 76
- Main Board Specifications 77
- Specifications: 78
- RF Specifications: 78
- Gateway 81
- Specifications 84
- Power Supply 87
- RF Specifications 88
- Antenna Interfaces 89
- Diversity WWAN Antenna 90
- GPS Antenna 90
- WLAN interface 91
- Antenna Recommendations 92
- Ethernet Specifications 93
- Yellow LED: 94
- Green LED: 94
- WAN/LAN Switchover Feature 95
- Environmental Specifications 97
- Power Requirements 97
- Internal Power Circuits 98
- SIM Card Requirements 100
- Safety warnings 101
- USR3510 3G Americas 103
- USR803510 3G EMEA 104
- Industry Canada (IC) 107
- USR Universe Guide 109
- Signing In 111
- Add a group 114
- Adding device(s) to a group 115
- Adding devices in bulk 116
- Displaying Group Software 120
- Edit Group Software 121
- Devices 124
- Manage and Sorting Devices 125
- Sorting the Device List 127
- Filter by search term 127
- Filter by device status 127
- Enabling Automatic Update 130
- Deactivating Devices 135
- Devices with Custom Settings 136
- User Roles 138
- Add a new user 139
- Change roles in a group 140
- Remove a user from a group 140
- Managing Software 141
- Managing System Firmware 142
- Managing Radio Firmware 143
- 2nd Floor 149
- Editing Your Account 151
- Troubleshooting 153
- Default 154
- Remote Login Enabled 154
- Port Forwarding Rules 155
- Automatic Update Flow Chart 156
- Licenses 158
Manuais e produtos relacionados com Gateways/controladores US Robotics USR803510
(136 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais